Carpet Sections

Teppich-Profiles

Rug tiles are square parts of rugs that are sometimes used instead of rolled rugs. As soon as the teppie parts are in place. The minimum requirements for carpet installation are covered in this section. Installing carpet tiles. Teppichfliesen, also known as carpet tiles or modular carpets, are available in prefabricated squares with their own integrated back and base.

Instructions on how to slice out part of the carpet & laminate | Home Guides

Carpets have their advantages and disadvantages, like most carpets. It' s smooth on your legs and on your whole being when you are on the ground to play with your children, and it' s cheaper than other kinds of floors such as wood. For this reason, you may want to take out part of the carpet in a busy area, such as your lobby or eating area, and substitute it with a more stable type of fabric.

Specify which part of your carpet you want to be removed. Use a universal blade to trim the painter's adhesive and carpet. Peel off the corners of the Velcro along the walls and unroll the carpet to be disposed of. Trim the glue stick at the side of the rest of the carpet by scratching it with a universal blade.

Use a sling bar to remove the undesired Velcro tape from the surface. Pull off the carpet slightly and remove about 1/2 in. of carpet upholstery. Measuring the length of the carpet edge. Using a saw with a sheet of steel, slice the rail for the floor junction rail to size to fit it.

Install the rail along the carpet edges and bolt it into the substrate. Use a universal blade to trim the base so that it fills the open area in the area. The skirting boards should be removed along the sides where you are installing the laminated wood floors by pulling them off with a crowbar. Place a sheet of paper between the crowbar and the side of the screen to prevent the screen from being damaged.

Install the first section of laminated sheeting along the walls or along the inner edges of a transitional sheet of strips. Use a 1/4 -inch distance maintainer between the laminated board and the rail or panel edges to provide an extension distance. Press a pearl laminated adhesive along the shorthand of the board, and push another board next to the first and start with the first line of laminated topping.

Trim the last slice of laminat in the line with a circle saw to size. Crease the top of the laminat first and then slice the board along the scoring area. Apply adhesive to the ledge and put it in place. Allow a 1/4 inch slit at the end where it hits the junction rail or partition.

Trim the first part of the second line into two halves. If you place it next to the first part of the first line, the stitching will not be in the same place as in the first line. Apply adhesive to the spring of the fitted part and to the slot of the new part and click it together.

Trim the transitional band to the length of the rails with a saw. Using a hammer, touch the slot of the rail with the stripe, beginning at one end and ending at the other end. In the case of fixed installation, this stripe keeps the cutting edges of the carpet in place and conceals the stretch distance on the side of the lamination.

When you remove a large slice of carpet, slice it into 3 foot width stripes to facilitate handling when you remove it.

Auch interessant

Mehr zum Thema